FixVault
Home › Nissan-Datsun › 2009 › Cube Base › Repair and Diagnosis › Electrical › Body Electrical › Power Control System › Power Distribution System › DTC/Circuit Diagnosis › DTC B26F2: Ignition Relay › Component Inspection

Component Inspection

  1. CHECK IGNITION RELAY
    1. Turn ignition switch OFF.
    2. Remove ignition relay.
    3. Check the continuity between ignition relay terminals.
    CONTINUITY REFERENCE CHART

    Terminals Condition Continuity
    3 and 5 12 V direct current supply between terminals 1 and 2 Existed
    No current supply Not existed
    Fig 1: Checking Continuity Between Ignition Relay Terminals
    G04889520Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace ignition relay.

About FixVault