DTC Confirmation Procedure
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
If the target idle speed is out of the specified value, perform Idle Air Volume Learning, ACCELERATOR PEDAL RELEASED POSITION LEARNING , before conducting DTC Confirmation Procedure. For the target idle speed, refer to the "SERVICE DATA AND SPECIFICATIONS (SDS) ", .
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
- Always perform the test at a temperature above -10°C (14°F).
- Open engine hood.
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and run it for at least 1 minute at idle speed.
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to , "DIAGNOSIS PROCEDURE ".