FixVault
Home › Nissan-Datsun › 2009 › Quest Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - Introduction › Service Information › Basic Service Procedure › Fuel Pressure Check › Fuel Pressure Release › Without CONSULT-III

Without CONSULT-III

  1. Remove fuel pump fuse located in IPDM E/R.
  2. Start engine.
  3. After engine stalls, crank it two or three times to release all fuel pressure.
  4. Turn ignition switch OFF.
  5. Reinstall fuel pump fuse after servicing fuel system.
Fig 1: Identifying Fuel Pump Fuse And Washer Tank Cap
G04905125Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault