Dismounting/Mounting Procedures: Notes

CAUTION: The tire should be dismounted from the wheel using the tire changer manufacturer's instructions. Use the following information to avoid damage during the dismounting/mounting procedures.

CAUTION: Ensure there is no metallized film or any metal parts (antenna, etc.) on the windows, as this may cause poor reception of the signals from tire pressure sensors, and the TPM system will not function properly.

CAUTION: If a PAX run flat tire and wheel (or tire pressure sensor) requires service, and the proper servicing equipment is not available, then replace the complete PAX tire and wheel assembly. DO NOT service these tires with conventional tire servicing equipment, or damage to tire and wheel will result.

NOTE: When a spare tire is mounted, or a wheel, tire pressure sensor or BCM is replaced, the tire pressure sensor must be registered. See RESET PROCEDURES .