PNP Switch

Check continuity between PNP switch harness connector terminals.

CONNECTOR TERMINAL CONTINUITY CHART

Selector lever position	Connector	Terminal	Continuity
P	F26	2 - 5, 6 - 7	Yes *Continuity should not exist in positions other than the specified positions.
R		5 - 8
N		3 - 5, 6 - 7
D		4 - 5
L		1 - 5

Fig 1: Checking Continuity Between PNP Switch Harness Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, check again with control cable (2) disconnected from manual shaft of CVT assembly. Refer to step 1.
(1): Manual shaft

(A): Lock nut
If OK on step 2, adjust control cable (2). Refer to "ADJUSTMENT OF CVT POSITION ".
If NG on step 2, remove PNP switch from CVT and check continuity of PNP switch terminals. Refer to step 1.
If OK on step 4, adjust PNP switch. Refer to "ADJUSTMENT OF PNP SWITCH ".
If NG on step 4, replace PNP switch. Refer to "PARK/NEUTRAL POSITION (PNP) SWITCH ".

Fig 2: Identifying Control Cable And Lock Nut

Courtesy of NISSAN MOTOR CO., U.S.A.