DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III

Turn ignition switch ON.
Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
Start engine and maintain the following conditions for at least 5 consecutive seconds.
RANGE: "D" position and "N" position

(At each time, wait for 5 seconds.)
If DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT-III".