FixVault
Home › Nissan-Datsun › 2009 › Sentra SE-R › Repair and Diagnosis › Transmission › Automatic Trans › Continuously Variable Transmission (CVT) › Service Information › DTC U1010 Transmission Control Module (Can) › Diagnosis Procedure

Diagnosis Procedure

  1. CHECK DTC

    With CONSULT-III 

    1. Turn ignition switch ON.
    2. Select "SELF-DIAG RESULTS" mode for "TRANSMISSION" with CONSULT-III.
    3. Touch "ERASE".
    4. Turn ignition switch OFF and wait for at least 10 seconds.
    5. Perform "DTC confirmation procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

    Is any malfunction of the "U1010 CONTROL UNIT(CAN)" indicated? 

    YES: Replace the TCM. Refer to "REMOVAL AND INSTALLATION ".

    NO: INSPECTION END 

About FixVault