FixVault
Home › Nissan-Datsun › 2010 › Altima Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 41 (Security Control System (Hybrid)) › Function Diagnosis › Intelligent Key System/Engine Start Function › System Description › Push-Button Ignition Switch Operation Procedure

Push-Button Ignition Switch Operation Procedure

WARNING: This page is about a different variant/trim than selected.

The power supply position changing operation can be performed with the following operations.

NOTE:
  • When an Intelligent Key is within the detection area of inside key antenna or when it is inserted to the key slot, it is equivalent to the operations below.
  • When starting the engine, the BCM monitors under the hybrid system start conditions,
    • Brake pedal operating condition
    • CVT selector lever position
    • Vehicle speed
    • Engine status
  • Unless each condition is fulfilled, the hybrid system will not respond regardless of how many times the hybrid system switch is pressed. At that time, illumination repeats the position in the order of LOCK → ACC → ON → OFF.
HYBRID SYSTEM REFERENCE CHART

Power supply position Hybrid system start/stop condition Push-button ignition switch operation frequency
Brake pedal CVT selector lever position
LOCK → ACC Not depressed Any position 1
LOCK → ACC → ON Not depressed Any position 2
LOCK → ACC → ON → OFF Not depressed Any position 3
LOCK → START
ACC → START
ON → START (Engine start)		 Depressed P((1)) 1
[If the switch is pressed once, the engine starts from any power supply position (LOCK, ACC, and ON)]
Engine is running → OFF (Engine stop) - Any position (vehicle speed <4 km/h) 1
Engine is running → ACC (Engine stop) - Any position other than P ((2)) 1
Engine stall return operation while driving - P position 1
(1) When the CVT selector lever position is N position, the engine start condition is different according to the vehicle speed.
  • At vehicle speed of 4 km/h or less, the engine can start only when the brake pedal is depressed.
  • At vehicle speed of 4 km/h or more, the engine can start even if the brake pedal is not depressed. (It is the same as "Engine stall return operation while driving".)

(2) When the CVT selector lever position is in any position other than P position and when the vehicle speed is 5 km/h or more, the engine stop condition is different.
  • Press and hold the push-button ignition switch for 2 seconds or more. (When the push-button ignition switch is pressed for too short a time, the operation may be invalid, so properly press and hold to prevent an incorrect operation.)
  • Press the push-button ignition switch 3 times or more within 1.5 seconds. (Emergency stop operation)
About FixVault