FixVault
Home › Nissan-Datsun › 2011 › 370Z Base, 2D Convertible, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System - 370Z - DTC P0181 Through P0607 › DTC P0196: EOT Sensor › Component Function Check

Component Function Check

  1. CHECK ENGINE OIL TEMPERATURE (EOT) SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect EOT sensor harness connector.
    3. Remove EOT sensor. Refer to "EXPLODED VIEW ".
    4. Check resistance between EOT sensor terminals by heating with hot water as shown in the figure.
    TERMINAL RESISTANCE

    Terminals Condition Resistance (kΩ)
    1 and 2 Temperature [°C (°F)] 20 (68) 2.10 - 2.90
    50 (122) 0.68 - 1.00
    90 (194) 0.236 - 0.260
    Fig 1: Checking Resistance Between Engine Coolant Temperature Sensor Terminals With Heating
    G07099830Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: Go to 2.

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

  2. CHECK INTERMITTENT INCIDENT

    Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

About FixVault