FixVault
Home › Nissan-Datsun › 2011 › Sentra SE-R › Repair and Diagnosis › Body & Frame › Door Locks › Body, Lock & Security System › Service Information › NATS(NISSAN Anti-Theft System) › ECM Re-communicating Function

ECM Re-communicating Function

Performing the following procedure can automatically perform re-communication of ECM and BCM or Intelligent Key unit, but only when the ECM has been replaced with a new one which has never been energized onboard.

(In this step, initialization procedure by CONSULT-III is not necessary)

NOTE:
  • When registering new Key IDs or replacing the ECM other than brand new, refer to the CONSULT-III operation Instructions.
  • If multiple keys are attached to the key holder, separate them before work.
  • Distinguish keys with unregistered key ID from those with registered ID.
  1. Install ECM.
  2. Use a registered key (*), turn ignition switch to "ON".

    *: To perform this step, use the key that has been used before to perform ECM replacement.

  3. Maintain ignition switch in "ON" position for at least 5 seconds.
  4. Turn ignition switch to "OFF".
  5. Start engine.

    If engine can be started, procedure is completed.

    If engine cannot be started, refer to the CONSULT-III operation Instructions and initialize control unit.

About FixVault