With Consult-III

1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
4. Check the following conditions are met.

   COOLAN TEMP/S: 0 - 100°C (32 - 212°F) 

   INT/A TEMP SE: 0 - 60°C (32 - 140°F) 

5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.

   Follow the instruction displayed.

   NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-III screen, GO TO "BASIC INSPECTION ".
6. Check that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".