FixVault
Home › Nissan-Datsun › 2011 › Sentra SE-R › Repair and Diagnosis › Engine Performance › System › Engine Control System - DTCS P0181 To P0500 (MR20DE) (Except CALIFORNIA) › DTC P0181 FTT Sensor › Diagnosis Procedure

Diagnosis Procedure

  1. CHECK GROUND CONNECTIONS
    1. Turn ignition switch OFF.
    2. Loosen and retighten ground screws on the body.

      Refer to "GROUND INSPECTION ".

      • : Vehicle front
      • Body ground (1)

    OK or NG 

    OK: GO TO 2.

    NG: Repair or replace ground connections.

    Fig 1: Location Of Body Ground
    G07139945Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit and fuel pump" harness connector (1).
      • : Vehicle front
    3. Turn ignition switch ON.
      Fig 2: Location Of Fuel Level Sensor Unit And Fuel Pump Harness Connector
      G07139946Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check voltage between "fuel level sensor unit and fuel pump" terminal 4 and ground with CONSULT-III or tester.

      Voltage: Approximately 5 V 

    OK or NG 

    OK: GO TO  4.

    NG: GO TO 3.

    Fig 3: Checking Voltage Between Fuel Level Sensor Unit And Fuel Pump Terminal 4 And Ground
    G07139947Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors B9, E13
    • Harness connectors E3, F2
    • Harness for open or short between ECM and "fuel level sensor unit and fuel pump"

      Repair open circuit or short to ground or short to power in harness or connector.

  4. CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect combination meter harness connector.
    3. Check harness continuity between "fuel level sensor unit and fuel pump" terminal 5 and combination meter terminal 4, ECM terminal 60. Refer to WIRING DIAGRAM .

      Continuity should exist  .

    4. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  6.

    NG: GO TO 5.

  5. CETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors B8, M8
    • Harness connectors B9, E13
    • Harness connectors E3, F2
    • Harness for open or short between "fuel level sensor unit and fuel pump" and combination meter.
    • Harness for open or short between "fuel level sensor unit and fuel pump" and ECM.

      Repair open circuit or short to ground or short to power in harness or connectors.

  6. CHECK FUEL TANK TEMPERATURE SENSOR

    Refer to, "COMPONENT INSPECTION ".

    OK or NG 

    OK: GO TO 7.

    NG: Replace "fuel level sensor unit and fuel pump". Refer to FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY .

  7. CHECK INTERMITTENT INCIDENT

    Perform TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    INSPECTION END 

About FixVault