FixVault
Home › Nissan-Datsun › 2011 › Versa Base, Automatic › Repair and Diagnosis › Transmission › Automatic Transaxle › Service Information › Shift Control System › Selector Lever Handle Removal and Installation › Removal

Selector Lever Handle Removal and Installation: Removal

CAUTION: Make sure that parking brake is applied before removal/installation.
  1. Place the selector lever handle (1) in "N" position.
  2. Slide handle cover (2) downward.
  3. Pull out lock pin (3) from selector lever handle (1).
  4. Remove selector lever handle (1) and handle cover (2) as a set from selector lever.
    CAUTION: Do not push selector button.
    Fig 1: Identifying Selector Lever Handle, Lock Pin And Handle Cover
    G06538586Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault