FixVault
Home › Nissan-Datsun › 2011 › Versa Base, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (CVT) › Service Information › Shift Control System › Adjustment of CVT Position

Adjustment of CVT Position

WARNING: This page is about a different variant/trim than selected.
CAUTION: Make sure that parking brake is applied before adjustment.
  1. Loosen the control cable nut (A) and place the manual lever (1) in "P" position.
  2. Place selector lever in "P" position.
  3. Push the control cable (2) in with a load of 9.8 N (approximately 1 kg, 2.2 lb). Release the control cable and temporarily tighten the control cable nut.
    NOTE: Do not move the manual lever. Make sure the manual lever stays in the "P" position.
  4. Tighten the control cable nut.
    CAUTION: Secure the manual lever when tightening nut.

    Control cable nut:  Refer to "REMOVAL AND INSTALLATION ".

    Fig 1: Locating Control Cable Nut And Manual Lever
    G06547869Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check the operation of the CVT. Refer to "CHECKING OF CVT POSITION ".
About FixVault