FixVault
Home › Nissan-Datsun › 2012 › Altima Base › Repair and Diagnosis › Engine Mechanical › Fuel System › Removal And Installation › EVAP Control System Pressure Sensor › Removal and Installation › Removal

Removal and Installation: Removal

  1. Remove rear stabilizer bar clamps and position rear stabilizer bar aside. Refer to REMOVAL AND INSTALLATION .
  2. Disconnect EVAP hose from EVAP canister.
  3. Disconnect EVAP control system pressure sensor.
  4. Remove EVAP control system pressure sensor and O-ring.
CAUTION: Discard the O-ring. Do not reuse O-ring.
About FixVault