Ignition Switch Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Do the battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ).
Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ).
Disconnect the 7P connector (A) from the ignition switch (B).

Fig 1: Locating 7P Connector And Ignition Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two screws and the ignition switch.
Install the parts in the reverse order of removal.
Do the battery terminal reconnection procedure (see RECONNECTION ).