Key Interlock Solenoid Test

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Remove the steering column covers (see COLUMN COVER REMOVAL/INSTALLATION ).
Disconnect the steering lock assembly 6P connector (A), and then turn the ignition switch to ACCESSORY (I).

Fig 1: Locating Steering Lock Assembly 6P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect power to steering lock assembly 6P connector terminal No. 4, and ground steering lock assembly 6P connector terminal No. 3, then try turning the ignition switch to LOCK (0); the ignition switch should not turn.
Disconnect power and ground from terminals, then turn the ignition switch to LOCK (0) and remove the key; the ignition switch should turn and the key can be removed.
If the key interlock solenoid does not work as specified, replace the steering lock assembly (see STEERING LOCK REPLACEMENT ).