FixVault
Home › Nissan-Datsun › 2012 › Cube SL › Repair and Diagnosis › Engine Performance › System › Engine Control System - DTCS P0605 To P2A00 (Except CALIFORNIA) › DTC P1715: Input Speed Sensor › DTC Logic › DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    >> GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Start engine and drive the vehicle at more than 50 km/h (31 MPH) for at least 5 seconds.
      CAUTION: Always drive vehicle at a safe speed.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES >> Go to "Diagnosis Procedure ".

    NO >> INSPECTION END

About FixVault