Diagnosis Procedure

1. Turn power switch OFF.
2. Disconnect rear power window switch connector.
3. Turn power switch ON.
4. Check voltage between rear power window switch harness connector and ground.

   (+)			(-)	Condition		Voltage (V) (Approx.)
   Rear power window switch
   Connector		Terminal
   LH	D63	2	Ground	Power window main switch (rear LH)	NEUTRAL	0 - 1
   					UP	9 - 16
   		3			NEUTRAL	0 - 1
   					DOWN	9 - 16
   RH	D43	2		Power window main switch (rear RH)	NEUTRAL	0 - 1
   					UP	9 - 16
   		3			NEUTRAL	0 - 1
   					DOWN	9 - 16

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn power switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and rear power window switch harness connector.

   Power window main switch		Rear power window switch			Continuity
   Connector	Terminal	Connector		Terminal
   D35	9	LH	D63	2	Existed
   	8			3
   	7	RH	D43	2
   	6			3

4. Check continuity between power window main switch harness connector and ground.

   Power window main switch		Ground	Continuity
   Connector	Terminal
   D35	9		Not existed
   	8
   	7
   	6

   Is the inspection result normal? 

   YES: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check rear power window switch.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Replace rear power window switch. Refer to "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END