Component Inspection

CHECK ACCELERATOR PEDAL POSITION SENSOR

Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage between ECM harness connector terminals under the following conditions.

ECM				Condition		Voltage (V)
+		-
Connector	Terminal	Connector	Terminal
E16	97 (APP sensor 1 signal)	E16	100 (Sensor ground)	Accelerator pedal	Fully released	0.5 - 1.0
	97 (APP sensor 1 signal)		100 (Sensor ground)		Fully depressed	4.2 - 4.8
	98 (APP sensor 2 signal)		116 (Sensor ground)		Fully released	0.25 - 0.50
	98 (APP sensor 2 signal)		116 (Sensor ground)		Fully depressed	2.0 - 2.5

Is the inspection result normal?

YES: INSPECTION END

NO: Replace accelerator pedal assembly. Refer to "EXPLODED VIEW ".