Inspection Procedure
- Check the amount of engine oil. Replenish if necessary. Refer to "INSPECTION ".
- Check for leak of the CVT fluid. Refer to "INSPECTION ".
- Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).
- Be sure to apply the parking brake and block the tires.
- Start the engine, depress the brake pedal and shift the selector lever to the "D" position.
- While depressing the brake pedal, depress the accelerator pedal gradually.
- Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.CAUTION: Never depress the accelerator pedal for 5 seconds or more during the test.
Stall speed : "STALL SPEED "
- Shift the selector lever to the "N" position.
- Cool the CVT fluid.CAUTION: Run the engine with the idle speed for at least 1 minute.
- Shift the selector lever to the "R" position and perform Step 6 to Step 9 again.RESULT OF INSPECTION
Stall speed "D" position "R" position Possible cause H O - Forward clutch
O H - Reverse brake
L L - Engine and torque converter one-way clutch
- Accelerator pedal position sensor
H H - Line pressure low
- Primary pulley
- Secondary pulley
- Steel belt
- O: Stall speed within standard value position.
- H: Stall speed is higher than standard value.
- L: Stall speed is lower than standard value.