DTC Confirmation Procedure
CAUTION:
Be careful not to overheat engine.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT.
- Check that "COOLAN TEMP/S" is above 20°C (68°F).
If it is above 20°C (68°F), the test result will be OK .
If it is below 20°C (68°F), go to following step .
- Start engine and run it for 65 minutes at idle speed.
If "COOLAN TEMP/S" increases to more than 20°C (68°F) within 65 minutes, stop engine because the test result will be OK .
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to
"DIAGNOSIS PROCEDURE ".
WITH GST
Follow the procedure "WITH CONSULT" above.