FixVault
Home › Nissan-Datsun › 2012 › Sentra SE-R › Repair and Diagnosis › Maintenance › Procedures › Maintenance Reminder Light (Reset Procedures) › Tire Pressure Monitor System Reminder › TPMS Reminder Reset - Procedure 02 › Transmitter Wake Up Operation

Transmitter Wake Up Operation

NOTE: Juke and Leaf models do not require the Transmitter Wake Up Operation.
  1. With the ignition switch in OFF position, connect scan tool to the Data Link Connector (DLC).
  2. Turn ignition switch to ON position.
  3. Display "WORK SUPPORT" screen, and select "ID REGIST".
  4. With the Transmitter Activation Tool (J-45295) pushed against the left front tire air-valve, press the button for 5 seconds. See Figure. Sensor activation must be performed in the specified order: left front, right front, right rear, left rear.
  5. On Altima & Sentra:  As each sensor ID is activated, the hazard warning lights and the TPMS warning light, flash 4 times, and the scan tool indicator light changes from red to green.

    All Other Models:  As each sensor ID is activated, the TPMS warning light flashes in the pattern shown below, and the scan tool LED changes from red to green.

    • Left Front: 1 Blink
    • Right Front: 2 Blinks
    • Right Rear: 3 Blinks
    • Left Rear: 4 Blinks
    • All Tires Completed: 1 Long Blink

  6. Check that the transmitter wake-up procedure for all wheels is completed using the scan tool.
  7. After completing wake up of all transmitters, make sure TPMS warning light goes out.
About FixVault