FixVault
Home › Nissan-Datsun › 2012 › Sentra SE-R › Repair and Diagnosis › Maintenance › Procedures › Maintenance Reminder Light (Reset Procedures) › Tire Pressure Monitor System Reminder › TPMS Reminder Reset - Procedure 03 › ID Registration With Transmitter Activation Tool

ID Registration With Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST". Select "START".
  6. With the Transmitter Activation Tool (J-45295) pushed against the front left transmitter tire air valve, press the button for 5 seconds.
  7. Register the IDs in the specified order: left front, right front, right rear, left rear
    NOTE: Note: Be sure to register the sensor IDs in the specified order, or the self-diagnostic results display will not function properly.
  8. As each sensor ID is registered, the turn signal lights flash twice and the scan tool indicator light changes from red to green. On some models, a buzzer or chime may sound.
  9. After completing all ID registrations, press "END" to complete the procedure.
About FixVault