FixVault
Home › Nissan-Datsun › 2013 › Altima Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - Component Testing (Qr25DE) (Sedan) › Brake Pedal Position Switch › Component Function Check

Component Function Check

  1. CHECK BRAKE PEDAL POSITION SWITCH FUNCTION 

    With CONSULT 

    1. Turn ignition switch ON.
    2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
    3. Check "BRAKE SW1" indication as per the following conditions.
      Monitor item Condition Indication
      BRAKE SW1 Brake pedal Slightly depressed OFF
      Fully released ON

    Without CONSULT 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals.
      ECM Condition Voltage
      Connector + -
      Terminal
      E10(1)
      E31(2)      		 116 128 Brake pedal Slightly depressed Approx. 0 V
      Fully released Battery voltage
      (1) Except for California
      (2) For California

      Is the inspection result normal? 

      YES >> INSPECTION END

      NO >> Proceed to "DIAGNOSIS PROCEDURE ".

About FixVault