Component Inspection

WITH CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
5. Check that the "FUEL PRES SEN V" indication.

   Monitor Item	Condition	Values/Status
   FUEL PRES SEN V	Engine speed: Idle	1, 140 - 1, 460 mV
   	Engine speed: Revving engine from idle to 4, 000 rpm quickly	1, 300 - 2, 900 mV

WITHOUT CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Check FRP sensor signal voltage.

   ECM			Condition	Value (Approx.)
   Connector	+	-
   	Terminal
   F25	18	44	[Engine is running] Warm-up condition Idle speed	1.14-1.46 V
   			[Engine is running] Warm-up condition Revving engine from idle to 4, 000 rpm quickly	1.3 - 2.9 V

   Is the inspection result normal? 

   YES: INSPECTION END.

   NO: Replace FRP sensor. Refer to "EXPLODED VIEW ".