Component Inspection

With CONSULT

1. Remove G sensor.
2. Reconnect all harness connectors disconnected.
3. Place the G sensor on a flat table.
4. Turn ignition switch ON.
5. Select "G SENSOR" in "DATA MONITOR" mode of "ENGINE" using CONSULT to check indications according to the following conditions:
   Fig 1: Identifying G Sensor Positions

   Courtesy of NISSAN NORTH AMERICA, INC.

   Monitor item	Condition	Value (V)
   G SENSOR	Parallel with the table (0G) (B)	2.18 - 2.82
   	Vertical to the table (-1G) (A) ↓ Parallel with the table (0G) (B) ↓ Vertical to the table (1G) (C)	0.85 - 1.49(1) ↓ 2.18 - 2.82(1) ↓ 3.51 - 4.15(1)
   (1) Check that voltage rises as the G sensor measurement condition changes in the order of (A), (B), and (C).

Without CONSULT

1. Remove G sensor.
2. Reconnect all harness connectors disconnected.
3. Place the G sensor on a flat table.
4. Turn ignition switch ON.
5. Check the voltage between ECM harness connector terminal and ground.
   Fig 2: Identifying G Sensor Positions

   Courtesy of NISSAN NORTH AMERICA, INC.

   +		-	Condition	Voltage (V)
   ECM
   Connector	Terminal
   F26	83	Ground	Parallel with the table (0G) (B)	2.18 - 2.82
   			Vertical to the table (-1G) (A) ↓ Parallel with the table (0G) (B) ↓ Vertical to the table (1G) (C)	0.85 - 1.49(1) ↓ 2.18 - 2.82(1) ↓ 3.51 - 4.15(1)
   (1) Check that voltage rises as the G sensor measurement condition changes in the order of (A), (B), and (C).

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Replace G sensor.