Power Supply Position Change Table By Push-Button Ignition Switch Operation
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
- When starting the engine, BCM checks the following conditions and then changes the power supply position.
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
- This models do not have the steering lock system. However, power supply position changes to the LOCK position without steering lock operation when the following conditions are fulfilled.
- Ignition switch: OFF
- Shift lever position: P
- Any of the following condition is met
- Opening door
- Closing door
- Door is locked by request switch operation
- Door is locked by Intelligent Key operation
POWER SUPPLY POSITION DESCRIPTION (FOR VEHICLE SPEED LESS THAN 4 KM/H (2.5 MPH))
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| LOCK → ACC | - | Not depressed | 1 |
| LOCK → ACC → ON | - | Not depressed | 2 |
| LOCK → ACC → ON → OFF | - | Not depressed | 3 |
| LOCK → START ACC → START ON → START |
P or N position | Depressed | 1 |
| Engine is running → OFF | - | - | 1 |
POWER SUPPLY POSITION DESCRIPTION (FOR VEHICLE SPEED 4 KM/H (2.5 MPH) OR MORE)
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → ACC | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.