FixVault
Home › Nissan-Datsun › 2013 › Sentra SL › Repair and Diagnosis › External Pages › Different car › Section 27 (Brake System) › Unit Disassembly And Assembly › Front Disc Brake › Disassembly And Assembly › Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install bleeder valve and cap.
  2. Apply rubber grease to piston seal (1), and install to cylinder body.
    G05207993Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston seal.

  3. Apply rubber grease to piston boot (1). Cover the piston (2) end with piston boot, and install cylinder side lip on piston boot securely into a groove on cylinder body.
    G05207994Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston boot.

  4. Apply new brake fluid to piston (1). Push piston into cylinder body by hand and push piston boot (2) piston-side lip into the piston groove.
    G05207995Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Press the piston evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.

About FixVault