DTC Confirmation Procedure

INSPECTION START
Do you have CONSULT?

Do you have CONSULT?

YES: GO TO 2.

NO: GO TO 5.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
  : GO TO 3.

CHECK PNP SIGNAL FUNCTION

With CONSULT

Turn ignition switch ON.

Select "P/N POSI SW" in "DATA MONITOR" mode of "ENGINE" using CONSULT. Then check the "P/N POSI SW" signal as per the following conditions.

Selector lever position	Known-good signal
N or P position (CVT) Neutral position (M/T)	ON
Except above position	OFF

Is the inspection result normal?

YES: GO TO 4.

NO: Proceed to "DIAGNOSIS PROCEDURE ".

PERFORM DTC CONFIRMATION PROCEDURE

Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
Start engine and warm it up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

CAUTION: Always drive vehicle at a safe speed.

ENG SPEED	1, 400 - 6, 375 RPM (CVT) 1, 675 - 6, 375 RPM (M/T)
COOLAN TEMP/S	More than 65°C (149°F)
B/FUEL SCHDL	1.6 - 31.8 msec
VHCL SPEED SE	More than 64 km/h (40 mph)
Selector lever	Suitable position

Check 1st trip DTC.
Is 1st trip DTC detected?

YES: Proceed to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END

PERFORM COMPONENT FUNCTION CHECK
Perform component function check. Refer to "COMPONENT FUNCTION CHECK ".

NOTE: Use component function check the overall function of the transmission range switch circuit (CVT models) or the park/neutral position (PNP) switch circuit (M/T models). During this check, a 1st trip DTC might not be confirmed.

Is the inspection result normal?

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".