Wake-Up Operation

BCM changes from the low power consumption mode to the CAN communication sleep mode when the any of the BCM wake-up conditions are fulfilled. Only the control with BCM is activated.
BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions are fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the combination meter transmits the wake up signal to BCM via CAN communication to report the CAN communication start.

BCM wake-up condition	CAN wake-up condition
Door unlock sensor: OFF→ON, ON→OFF Door lock assembly LH (key cylinder switch): Lock or unlock Door lock switch: OFF→ON Door unlock switch: OFF→ON Trunk lid opener switch: OFF→ON Power window serial link communication: Receiving Remote keyless entry receiver: Receiving valid keyfob	Receiving the sleep-ready signal (Not-ready) from any units Push-button ignition switch (push switch): OFF→ON Hazard switch: OFF→ON PASSING switch: OFF→ON, ON→OFF TAIL LAMP switch: OFF→ON Front door switch LH: OFF→ON, ON→OFF Front door switch RH: OFF → ON, ON → OFF Trunk lamp switch: OFF→ON, ON→OFF Driver door request switch (if equipped): OFF→ON Passenger door request switch (if equipped): OFF→ON Stop lamp switch 2 signal: ON Remote keyless entry receiver: Receiving valid keyfob

BCM wake-up condition

CAN wake-up condition