Power Window Serial Link Check

1. Remove key and close the front door LH and RH.
2. Check signal between BCM connector M19 and ground with oscilloscope when door lock and unlock switch (LH and RH) is turned to "LOCK" or "UNLOCK".
3. Check that signals which are shown in the figure below can be detected during 10 second just after door lock and unlock switch (LH and RH) is turned to "LOCK" or "UNLOCK".

   Terminal			Signal (Reference Value)
   (+)		(-)
   BCM Connector	Terminal
   M19	54	Ground	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

Power window serial link is OK.

NO 

GO TO STEP 2. 

1. Turn ignition switch OFF.
2. Disconnect BCM connector M19.
3. Check continuity between BCM connector M19 and power window and door lock/unlock switch RH connector D105.

   BCM Connector	Terminal	Power Window And Door Lock/Unlock Switch RH Connector	Terminal	Continuity
   M19	54	D105	3	Yes

4. Check continuity between BCM connector M19 and ground.

   BCM Connector	Terminal	Ground	Continuity
   M19	54		No

Is the inspection result normal?

YES 

Replace main power window and door lock/unlock switch. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace the harness or connectors.