Wake-Up Operation
WARNING: This page is about a different car, the 2016 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions are fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
- Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the combination meter transmits the wake up signal to BCM via CAN communication to report the CAN communication start.
| BCM wake-up condition |
CAN wake-up condition |
- Door unlock sensor: OFF→ON, ON→OFF
- Door lock assembly LH (key cylinder switch): Lock or unlock
- Door lock switch: OFF→ON
- Door unlock switch: OFF→ON
- Back door opener switch: OFF→ON
- Power window serial link communication: Receiving
- Remote keyless entry receiver: Receiving valid keyfob
|
- Receiving the sleep-ready signal (Not-ready) from any units
- Push-button ignition switch (push switch): OFF→ON
- Hazard switch: OFF→ON
- PASSING switch: OFF→ON, ON→OFF
- TAIL LAMP switch: OFF→ON
- Front door switch LH: OFF→ON, ON→OFF
- Front door switch RH: OFF → ON, ON → OFF
- Back door opener switch: OFF→ON, ON→OFF
- Driver door request switch: OFF→ON
- Passenger door request switch: OFF→ON
- Back door request switch: OFF→ON
- Stop lamp switch signal: ON
- Remote keyless entry receiver: Receiving valid keyfob
|