Test Item

Test item	Condition	Judgement	Check item (Remedy)
VENT CONTROL/V	Ignition switch: ON (Engine stopped) Turn solenoid valve ON and OFF with the CONSULT and listen to operating sound.	Solenoid valve makes an operating sound.	Harness and connectors Solenoid valve
ENG COOLANT TEMP	Engine: Return to the original trouble condition Change the engine coolant temperature using CONSULT.	If trouble symptom disappears, see Check item.	Harness and connectors Engine coolant temperature sensor Fuel injector
FUEL INJECTION	Engine: Return to the original trouble condition Change the amount of fuel injection using CONSULT.	If trouble symptom disappears, see Check item.	Harness and connectors Fuel injector Air fuel ratio (A/F) sensor 1
FUEL/T TEMP SEN	Change the fuel tank temperature using CONSULT.
PURG VOL CONT/V	Engine: After warming up, run engine at 1, 500 RPM. Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.	Engine speed changes according to the opening percent.	Harness and connectors Solenoid valve
FUEL PUMP RELAY	Ignition switch: ON (Engine stopped) Turn the fuel pump relay ON and OFF using CONSULT and listen to operating sound.	Fuel pump relay makes the operating sound.	Harness and connectors Fuel pump relay
IGNITION TIMING	Engine: Return to the original trouble condition Timing light: Set Retard the ignition timing using CONSULT.	If trouble symptom disappears, see Check item.	Perform Idle Air Volume Learning.
V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change intake valve timing using CONSULT.	If malfunctioning symptom disappears, see Check item.	Harness and connectors Intake valve timing control solenoid valve
VIAS S/V-1	Ignition switch: ON Turn solenoid valve ON and OFF with CONSULT and listen for operating sound.	Solenoid valve makes an operating sound.	Harness and connectors Solenoid valve
COOLING FAN *	Ignition switch: ON Turn the cooling fan HI, LOW and OFF using CONSULT.	Cooling fan moves and stops.	Harness and connectors Cooling fan motor IPDM E/R
POWER BALANCE	Engine: After warming up, idle the engine. A/C switch: OFF Shift lever: P or N Cut off each fuel injector signal one at a time using CONSULT.	Engine runs rough or stops.	Harness and connectors Compression Fuel injector Power transistor Spark plug Ignition coil

* : Leaving cooling fan OFF with CONSULT while engine is running may cause the engine to overheat.