Setting The ICC Target Board: Description

Accurate adjustment of the ICC sensor alignment requires that the ICC target board be accurately positioned.

1. ICC TARGET BOARD FINAL SETTING
   
   
   1. With the ICC target board arm extended, the laser beam (1) emitted by the laser assembly (A) will be reflected back (B) toward the laser assembly.

      Courtesy of NISSAN NORTH AMERICA, INC.

      NOTE:

      When adjusted properly, reflected laser beam (B) must align with emitted laser beam (A) and the two laser beams will be seen as one.

   2. Rotate the ICC target board to achieve the necessary horizontal adjustment.
   3. Adjust the ICC target board leveling screws to achieve the necessary vertical adjustment.
   4. The figure shown illustrates the laser beam (A) emitted by the laser assembly (1) and its reflection (B) off the ICC target board arm.

      Courtesy of NISSAN NORTH AMERICA, INC.

   GO TO STEP 2. 

2. CHECK THE POSITION OF THE ICC TARGET BOARD
   
   

   Do not place anything other than the ICC target board in the space shown in front of the vehicle (view from top).

   Courtesy of NISSAN NORTH AMERICA, INC.

   1.	ICC target board arm	2.	ICC target board	3.	ICC sensor
   4.	Vehicle	A .	Distance between front wheel and laser beam (Df)	B.	Distance between rear wheel and laser beam (Dr)
   C.	Height between front laser beam and ground (Hf)	D.	Height between rear laser beam and ground (Hr)	E.	ICC target board center position (Position 2)
   L.	1 - 1.5 m (39.3 - 59 in.)

   Refer to ICC SENSOR ADJUSTMENT .