Description - Power Supply Position Change Table By Push-Button Ignition Switch Operation
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
Vehicle Speed: Less Than 4 km/h (2.5 MPH)
| Power Supply Position | Engine Start/Stop Condition | Push-Button Ignition Switch Operation Frequency | |
|---|---|---|---|
| Selector Lever Position | Brake Pedal Operation Condition | ||
| OFF → ACC | - | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | 3 |
| OFF → START ACC → START ON → START |
P or N position | Depressed | 1 |
| Engine is running → OFF | - | - | 1 |
Vehicle Speed: 4 km/h (2.5 MPH) Or More
| Power Supply Position | Engine Start/Stop Condition | Push-Button Ignition Switch Operation Frequency | |
|---|---|---|---|
| Selector Lever Position | Brake Pedal Operation Condition | ||
| Engine is running → ACC | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.