Wake-up operation

BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions is fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the combination meter transmits the wake up signal to BCM via CAN communication to report the CAN communication start.

Wake-up condition

BCM wake-up condition

CAN wake-up condition

Door unlock sensor: OFF→ON, ON→OFF
Front door lock assembly LH [key cylinder switch (if equipped)]: Lock or unlock
Door lock switch: OFF→ON
Door unlock switch: OFF→ON
Trunk lid opener switch: OFF→ON
Power window serial link communication: Receiving
Remote keyless entry receiver: Receiving valid key fob

Receiving the sleep-ready signal (Not-ready) from any units
Push-button ignition switch (push switch): OFF→ON
Hazard switch: OFF→ON
PASSING switch: OFF→ON, ON→OFF
TAIL LAMP switch: OFF→ON
Front door switch LH: OFF→ON, ON→OFF
Front door switch RH: OFF → ON, ON → OFF
Trunk room lamp switch: OFF→ON, ON→OFF
Front door request switch LH: OFF→ON
Front door request switch RH: OFF→ON
Trunk opener request switch: OFF→ON
Stop lamp switch 2 signal: ON
Remote keyless entry receiver: Receiving valid key fob