Work Procedure
- CHOOSE METHOD
There are two setting methods.
Which method do you choose?
With CONSULT
GO TO STEP 2 .
With set switch
GO TO STEP 4 .
- WITH CONSULT - STEP 1
CONSULT
Select "Work support" mode of "AUTO DRIVE POS.".
GO TO STEP 3 .
- WITH CONSULT - STEP 2
- Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON and OFF.
- EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
- EXIT TILT SETTING: Entry/exit assist (steering column)
- Select "SEAT SLIDE VOLUME SET" and touch either "40 mm", "80 mm", or "150 mm".
- Then touch "OK".
Inspection End.
- Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON and OFF.
- WITH SET SWITCH - STEP 1
Turn ignition switch OFF.
GO TO STEP 5 .
- WITH SET SWITCH - STEP 2
Push set switch and hold for more than 10 seconds then confirm blinking of the memory switch indicator.
- Entry/exit assist (seat/steering column) is ON: Memory switch indicator blinks two times.
- Entry/exit assist (seat/steering column) is OFF: Memory switch indicator blinks once.
Inspection End.