Active Test

WARNING: This page is about a different car, the 2018 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Never perform "Active Test" while driving the vehicle.
The "Active Test" cannot be performed when the following systems malfunction is displayed.
- ICC system
- Blind Spot Warning/RCTA
- FEB
The "Active Test" cannot be performed when the FEB warning lamp is illuminated.
The "Active Test" cannot be performed when the ICC System is ON.

Test item	Description
METER LAMP	The FEB warning lamp can be illuminated by ON/OFF operation as necessary.
STOP LAMP	The ICC brake hold relay can be operated by ON/OFF operation as necessary, and the stop lamp can be illuminated.
ADAS Buzzer 2	Sounds a buzzer used for BSW, RCTA, ICC and FEB by arbitrarily operating ON/OFF.
Switch lamp	The warning system ON indicator (on warning system switch) can be illuminated by ON/OFF operation as necessary.
BRAKE ACTUATOR 1	Activates the brake by an arbitrary operation.
BRAKE ACTUATOR 2
BRAKE ACTUATOR 3
METER BUZZER	Sounds a buzzer used for ICC, PFCW, FEB by arbitrarily operating ON/OFF.

METER LAMP

NOTE: The test can be performed only when the engine is running.

Test item	Operation	Description	FEB warning lamp
METER LAMP	Off	Stops sending the FEB warning lamp signal to exit from the test.	OFF
METER LAMP	On	Transmits the FEB warning lamp signal to the combination meter via CAN communication.	ON

STOP LAMP

Test item	Operation	Description	Stop lamp
STOP LAMP	Off	Stops transmitting the ICC brake hold relay drive signal to end the test.	OFF
STOP LAMP	On	Transmits the ICC brake hold relay drive signal.	ON

ADAS BUZZER 2

Test item	Operation	Description	Operation sound
ADAS buzzer 2	On	Starts buzzer output.	OFF
ADAS buzzer 2	Off	Stops buzzer output.	ON

SWITCH LAMP

Test item	Operation	Description	Warning system ON indicator
Switch lamp	Off	Stops transmitting the warning system ON indicator (on warning system switch) signal to end the test.	OFF
Switch lamp	On	Transmits the warning system ON indicator (on warning system switch) signal to start the test.	ON

BRAKE ACTUATOR

NOTE: The test can be performed only when the engine is running.

Test item	Operation	Description	"PRESS ORDER" value
BRAKE ACTUATOR 1	Off	Stops transmitting the brake fluid pressure control signal to end the test.	-
BRAKE ACTUATOR 1	On	Starts transmitting the brake fluid pressure control signal to start the test.	10 bar
BRAKE ACTUATOR 2	Off	Stops transmitting the brake fluid pressure control signal to end the test.	-
BRAKE ACTUATOR 2	On	Starts transmitting the brake fluid pressure control signal to start the test.	20 bar
BRAKE ACTUATOR 3	Off	Stops transmitting the brake fluid pressure control signal to end the test.	-
BRAKE ACTUATOR 3	On	Starts transmitting the brake fluid pressure control signal to start the test.	30 bar

NOTE: The test is finished 10 seconds after starting.

Courtesy of NISSAN NORTH AMERICA, INC.

METER BUZZER

Test item	Operation	Description	Operation sound
METER BUZZER	Off	Stops buzzer output to the combination meter via CAN communication.	OFF
METER BUZZER	On	Starts buzzer output to the combination meter via CAN communication.	ON