FixVault
Home › Nissan-Datsun › 2019 › Maxima S › Repair and Diagnosis › Brakes › Brakes Control Systems › Chassis Control System › Chassis Control › DTC/Circuit Diagnosis › DTC C1BA3-00: Control Module › DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the power switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF to ON.
      CAUTION: Be sure to wait of 10 seconds after turning power switch OFF or ON.
    2. Select "Self-Diagnostic Result" mode of "CHASSIS CONTROL".

    Is DTC "C1BA3-00" detected?

    YES

    Refer to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End

About FixVault