Work Procedure

With CONSULT

1. Set parking brake.
2. Turn ignition switch ON.
3. Select "Work Support" in "TRANSMISSION".
4. Select "ERASE MEMORY DATA".
5. While maintaining the conditions below, touch "Start".
   • Vehicle stop status
   • With engine stopped
   • Selector lever: "R" position
   • Accelerator pedal: Depressed

Is "COMPLETED" displayed?

YES

GO TO 2.

NO

Turn ignition switch OFF and wait for a minimum of 20 seconds then perform the work again.

With CONSULT

1. Turn ignition switch OFF with the selector lever in "R" position and wait for 20 seconds or more.
2. Turn ignition switch ON with the selector lever in "R" position.
   CAUTION: Never start the engine.
3. Select "CALIB DATA" in "TRANSMISSION".
4. Check that indicated value of "CALIB DATA" is equal to the value shown in the following table.

   Item name	Display value
   C/V CLB ID	00
   UNIT CLB ID	00

Is the indicated value of "CALIB DATA" equal to the value shown in the table?

YES

GO TO 3.

NO

GO TO 1.

1. Shift the selector lever to the "P" position.
2. Check that "P" is displayed on shift position indicator on combination meter.
   NOTE: Displayed approximately 5 seconds after the selector lever is moved to the "P" position.

Does shift position indicator display "P"?

YES

GO TO 4.

NO

GO TO 5.

1. Turn ignition switch OFF and wait for 5 seconds.
2. Turn ignition switch ON.

Does the shift position indicator display "P" at the same time when turning ON the ignition switch?

YES

WORK END

NO

Check harness between battery and TCM harness connector terminal. Refer to Diagnosis Procedure .

Check the following items:

• Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
• Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals

Is the inspection result normal?

YES

GO TO 1.

NO

Repair or replace the malfunctioning parts.