Work Procedure: Inspection
- Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to Inspection .
- Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80 deg.C (122 to 176 deg.F).
- Inspect the amount of ATF. Replenish if necessary. Refer to Inspection .
- Securely engage the parking brake so that the tires do not turn.
- Start the engine, apply foot brake, and place selector lever in "D" position.
- Gradually press down the accelerator pedal while holding down the foot brake.
- Quickly read off the stall speed, then quickly release the accelerator pedal.CAUTION: Never hold down the accelerator pedal for more than 5 seconds during this test.
Stall speed
: Refer to Stall Speed .
- Shift the selector lever to "N" position.
- Cool down the ATF.CAUTION: Run the engine at idle for at least 1 minute.
- Repeat steps 6 through 9 with selector lever in "1", "2" and "R" positions.