Consult Data Monitor Standard Value
|
Monitor item |
Condition |
Reference value in normal operation |
|
IGN VOLT |
Ignition switch ON |
10 - 16 V |
|
CONTROL MODULE MALF |
When chassis control module (with built in steering angle sensor) is normal |
Off |
|
When chassis control module (with built in steering angle sensor) malfunction is detected |
On |
|
|
CAN DIAG STATUS |
When diagnosis of CAN communication malfunction is detected |
Off |
|
When diagnosis of CAN communication is normal |
On |
|
|
VEHICLE SPEED |
Vehicle stopped |
0 km/h |
|
Vehicle driving * |
Almost same reading as speedometer (Within +/-10%) |
|
|
FR WHEEL SPEED |
Vehicle stopped |
0 RPM |
|
Vehicle driving * |
Increases according to vehicle speed |
|
|
FL WHEEL SPEED |
Vehicle stopped |
0 RPM |
|
Vehicle driving * |
Increases according to vehicle speed |
|
|
RR WHEEL SPEED |
Vehicle stopped |
0 RPM |
|
Vehicle driving * |
Increases according to vehicle speed |
|
|
RL WHEEL SPEED |
Vehicle stopped |
0 RPM |
|
Vehicle driving * |
Increases according to vehicle speed |
|
|
STEERING ANG SENSOR |
When vehicle driving straight |
0+/-2.5 deg |
|
When steering wheel is steered to RH by 90 deg. |
Approx. +90 deg |
|
|
When steering wheel is steered to LH by 90 deg. |
Approx. -90 deg |
|
|
DECEL G SENSOR |
Vehicle stopped |
Approx. 0.01 G |
|
When during acceleration |
Positive value |
|
|
When during deceleration |
Negative value |
|
|
SIDE G SENSOR |
Vehicle stopped |
Approx. 0 G |
|
When right turn |
Negative value |
|
|
When left turn |
Positive value |
|
|
YAW RATE SENSOR |
Vehicle stopped |
Approx. 0 deg/s |
|
When right turn |
Negative value |
|
|
When left turn |
Positive value |
|
|
ACCELE PEDAL POSITION |
When accelerator pedal is released |
0% |
|
When accelerator pedal is depressed |
0 - 100% |
|
|
THROTTLE CONTROL |
When electric throttle control actuator is normal |
NORMAL |
|
When electric throttle control actuator does not achieve the requirement (measured value is inaccurate) |
INCORR |
|
|
When electric throttle control actuator does not achieve the requirement (temporary prevention) |
PREV |
|
|
When electric throttle control actuator does not achieve the requirement (impossible) |
INPOSSI |
|
|
SHIFT POSITION |
NOTE:
The item is indicated, but not monitored.
|
-- |
|
BRAKE SWITCH 2 |
When brake pedal is not depressed |
Off |
|
When brake pedal is depressed |
On |
|
|
BRAKE SWITCH 1 |
When brake pedal is not depressed |
Off |
|
When brake pedal is depressed |
On |
|
|
STOP LAMP SW |
When brake pedal is depressed |
ACT |
|
When brake pedal is not depressed |
INACT |
|
|
PRESS SENSOR |
When brake pedal is not depressed |
Approx. 0 bar |
|
When brake pedal is depressed |
0 - 250 bar |
|
|
ABS |
When ABS function is normal |
NORMAL |
|
When ABS function malfunction is detected |
ABNOR |
|
|
ABS MALF |
When ABS function is normal |
NORMAL |
|
When ABS function malfunction is detected |
ABNOR |
|
|
EBD |
When EBD function is normal |
NORMAL |
|
When EBD function malfunction is detected |
ABNOR |
|
|
TCS |
When TCS function is normal |
NORMAL |
|
When TCS function malfunction is detected |
ABNOR |
|
|
TCS MALF |
When TCS function is normal |
NORMAL |
|
When TCS function malfunction is detected |
ABNOR |
|
|
VDC |
When VDC function is normal |
NORMAL |
|
When VDC function malfunction is detected |
ABNOR |
|
|
VDC MALF |
When VDC function is normal |
NORMAL |
|
When VDC function malfunction is detected |
ABNOR |
|
|
VDC OFF SWITCH |
When VDC OFF switch is OFF |
Off |
|
When VDC OFF switch is ON |
On |
|
|
ATC 1 |
When intelligent trace control function is inactive |
Off |
|
When intelligent trace control function is active |
On |
|
|
ATC 2 |
When intelligent trace control function is inactive |
Off |
|
When intelligent trace control function is active |
On |
|
|
ATC 4 |
When intelligent trace control function is inactive |
Off |
|
When intelligent trace control function is active |
On |
|
|
BRAKE HOLD |
When brake fluid pressure is hold |
ACT |
|
When brake fluid pressure is not hold |
INACT |
|
|
When brake fluid pressure is decreases |
RELEA |
|
|
ATC 3 |
When intelligent trace control function is inactive |
Off |
|
When intelligent trace control function is active |
On |
|
|
FL TIRE DISP |
When the front LH tire is not displayed on the information display in the combination meter |
DEF |
|
When the front LH tire is displayed on the information display in the combination meter |
1 |
|
|
FR TIRE DISP |
When the front RH tire is not displayed on the information display in the combination meter |
DEF |
|
When the front RH tire is displayed on the information display in the combination meter |
1 |
|
|
RL TIRE DISP |
When the rear LH tire is not displayed on the information display in the combination meter |
DEF |
|
When the rear LH tire is displayed on the information display in the combination meter |
1 |
|
|
RR TIRE DISP |
When the rear RH tire is not displayed on the information display in the combination meter |
DEF |
|
When the rear RH tire is displayed on the information display in the combination meter |
1 |
|
|
VEHICLE DISP |
When the active ride control (brake control) function is not displayed on the information display in the combination meter |
DEF |
|
When the active ride control (brake control) function is displayed on the information display in the combination meter |
1 |
|
|
INTERRUPT DISP |
When not interrupt displayed on the information display in the combination meter |
NO REQ |
|
When the hill start assist function is not interrupt displayed on the information display in the combination meter |
HOLD 1 |
|
|
When the hill start assist function is not interrupt displayed on the information display in the combination meter |
HOLD 2 |
|
|
TURN DISP |
When the straight-ahead status is displayed on the information display in the combination meter |
N STEER |
|
When the left turning status is displayed on the information display in the combination meter |
LEFT |
|
|
When the right turning status is displayed on the information display in the combination meter |
RIGHT |
|
|
ATC DISP |
When the activation of intelligent trace control function is not displayed on the information display in the combination meter |
Off |
|
When the activation of intelligent trace control function is displayed on the information display in the combination meter |
On |
|
|
AEB |
When intelligent engine brake function is inactive |
Off |
|
When intelligent engine brake function is active |
On |
|
|
ATC 5 |
When intelligent trace control function is inactive |
Off |
|
When intelligent trace control function is active |
On |
|
|
ARC BRAKE |
When active ride control (brake control) function is inactive |
Off |
|
When active ride control (brake control) function is active |
On |
|
|
HDC DISP |
Displayed but not used |
-- |
|
BRAKE HOLD DISP |
When the operation condition is satisfied (inactive) status of hill start assist function is displayed on the information display in the combination meter |
ACT |
|
When the operation condition is not satisfied status of hill start assist function is displayed on the information display in the combination meter |
INACT |
|
|
When the activation status of hill start assist function is displayed on the information display in the combination meter |
RELEA |
|
|
AEB CVT PERMIT |
When transaxle control is not authorized |
Off |
|
When transaxle control is authorized |
On |
|
|
AEB STATUS |
When intelligent engine brake (brake control) function is inactive. |
Off |
|
When intelligent engine brake (brake control) function is active |
On |
|
|
AEB COMMAND 1 |
When intelligent engine brake function is inactive |
0 - 0.1023 G |
|
When intelligent engine brake function is active |
0 G |
|
|
AEB COMMAND 2 |
Displayed but not used |
-- |
|
AEB SLIP RATE |
When slip ratio of intelligent engine brake function is inactive |
0% |
|
When slip ratio of intelligent engine brake function is active |
0 - 100% |
|
|
ATC SETTING |
When intelligent trace control function is ON by steering switch |
On |
|
When intelligent trace control function is OFF by steering switch |
Off |
|
|
AEB SETTING |
When intelligent engine brake function is ON by steering switch |
On |
|
When intelligent engine brake function is OFF by steering switch |
Off |
|
|
Buckle switch |
When seat belt (driver side) is fastened |
On |
|
When seat belt (driver side) is unfastened |
Off |
|
|
VDC (ABH active) |
When automatic brake hold active is possible |
Possible |
|
When automatic brake hold active is impossible |
Impossi |
|
|
ABH (CCM) |
When automatic brake hold is active |
On |
|
When automatic brake hold is inactive |
Off |
|
|
Slope |
When slope is slow |
Slow |
|
When slope is steep |
Steep |
|
|
PB active request (VDC) |
When active of parking brake is requested [ABS actuator and electric unit (control unit)] |
REQ |
|
When active of parking brake is not requested [ABS actuator and electric unit (control unit)] |
NO REQ |
|
|
CCM (VDC) |
When chassis control module (with built in steering angle sensor) is normal |
Normal |
|
When chassis control module (with built in steering angle sensor) is abnormal |
Abnormal |
|
|
PB active request (CCM) |
When active of parking brake is requested [chassis control module (with built in steering angle sensor)] |
REQ |
|
When active of parking brake is not requested [chassis control module (with built in steering angle sensor)] |
NO REQ |
|
|
ABH active request (CCM) |
When active of automatic brake hold is requested [chassis control module (with built in steering angle sensor)] |
REQ |
|
When active of automatic brake hold is not requested [chassis control module (with built in steering angle sensor)] |
NO REQ |
|
|
ABH malfunction |
When automatic brake hold is normal |
Normal |
|
When automatic brake hold is abnormal |
Ab normal |
|
|
ABH indicator lamp |
When automatic brake hold indicator lamp is turn OFF |
Off |
|
When automatic brake hold indicator lamp is turn ON (white) |
On 1 |
|
|
When automatic brake hold indicator lamp is turn ON (green) |
On 2 |
|
|
ABH active request (ADAS) 1 |
Displays but not used |
-- |
|
PB |
After parking brake is release |
RLS 1 |
|
During parking brake is release |
RLS 2 |
|
|
After parking brake is active |
APP 1 |
|
|
During parking brake is active |
APP 2 |
|
|
CCM (PB) |
When chassis control module (with built in steering angle sensor) is normal |
Normal |
|
When chassis control module (with built in steering angle sensor) is abnormal |
Ab normal |
|
|
PB (ABH active) |
When automatic brake hold active is possible |
Possible |
|
When automatic brake hold active is impossible |
Impossi |
|
|
PB malfunction status |
When parking brake is normal |
Normal |
|
When parking brake is abnormal |
ABN 1 |
|
|
When parking brake is abnormal |
ABN 2 |
|
|
When parking brake is not used |
Not used |
|
|
ABH active request (ADAS) 2 |
Displays but not used |
-- |
|
ABH active request (ADAS) 3 |
Displays but not used |
-- |
|
ADAS |
Displays but not used |
-- |
|
ABH SW |
When automatic brake hold switch is ON |
On |
|
When automatic brake hold switch is OFF |
Off |
|
|
ABH SW indicator lamp |
When automatic brake hold indicator is turn ON |
On |
|
When automatic brake hold indicator is turn OFF |
Off |
|
|
ABH active judge (CCM) |
When automatic brake hold active condition is satisfied [judgement of chassis control module (with guilt in steering angle sensor)] |
OK |
|
When automatic brake hold active condition is not satisfied [judgement of chassis control module (with guilt in steering angle sensor)] |
NG |
|
|
Master warning |
When master warning lamp is turn ON |
On |
|
When master warning lamp is turn OFF |
Off |
|
|
PB SW |
|
Off |
|
When electric parking brake switch is pushed with depressing brake pedal |
Release |
|
|
ABH (ADAS) |
Displays but not used |
-- |
*: Check tire pressure under normal conditions.