Symptom Table
- Perform "Data Monitor" of CONSULT to check for any malfunctioning item.
- Check the malfunction combinations.
Malfunction item: x
Data monitor item
Combination switch circuit
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
INPUT 6
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
OUTPUT 5
FR WIPER HI
x
x
FR WIPER LOW
x
x
FR WASHER SW
x
x
FR WIPER INT
x
x
INT VOLUME
x
x
x
x
TURN SIGNAL R
x
x
TURN SIGNAL L
x
x
TAIL LAMP SW
x
x
HI BEAM SW
x
x
HEAD LAMP SW
x
x
NO LIGHT SW
x
x
PASSING SW
x
x
AUTO LIGHT SW
x
x
FR FOG SW
x
x
FR wiper stop
x
x
- Identify the malfunctioning part from the agreed combination and repair or replace the part.
Malfunctioning part
Repair or replace
Combination switch INPUT circuit
Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
Combination switch OUTPUT circuit
Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
All Items
Replace BCM. Refer to Removal and Installation .
If only one item is detected or the item is not applicable to the combinations
Replace combination switch. Refer to Removal and Installation .
All Items are normal
Check intermittent incident. Refer to Inspection .