Application Items

CONSULT can display each diagnostic item using the diagnostic test modes as follows.

Diagnosis mode	CGW Status			Description
Diagnosis mode	Restricted Mode	Diag Test Mode	Open Mode	Description
Self Diagnostic Result	Display	Display	Display	Display non-network DTC which chassis control module memorizes
CGW Information	Display	Display	Display	Display the current CGW mode Enables CGW to switch mode
Data Monitor	Display	Display	Display	Displays chassis control module input/output data in real time
Active Test	Nondisplay	Display	Display	Enables an operational check of a load by transmitting a driving signal from the chassis control module to the load
ECU Identification	Display	Display	Display	Displays chassis control module part number
Re/programming, Configuration ^*1	Display	Display	Display	The vehicle specification that is written in chassis control module can be displayed or stored The vehicle specification can be written when chassis control module is replaced
Network-DTC	Display	Display	Display	Display network DTC which chassis control module memorizes when performing "Diagnosis (All System)".
CAN Diag Support Monitor ^*2	Display	Display	Display	NOTE: The mode is indicated, but not monitored
MAC Diagnosis ^*2	Display	Display	Display	Display MAC diagnosis result divided into the following two inspection priorities. Inspection Priority 1: Root cause Inspection Priority 2

*1: After work, preform self-diagnosis for "All DTC Reading" and erase self-diagnosis result.

*2: Displays when performing "Diagnosis (All System)".