Work Procedure
- Perform action test to verify the customer's concern.
- Perform action test and check the system operation after system diagnosis.
- Fully understand the following items well before the road test;
- System description for TSR: Refer to System Description .
- Handling precaution: Refer to Precautions for Traffic Sign Recognition .
- CHECK TSR SYSTEM SETTING
- Start the engine.
- After starting the engine wait for 30 seconds or more.
- Enable the setting of the TSR system on the information display.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 2.
- ACTION TEST FOR LDW
- Enable the setting of the TSR system on the information display.
- Check the TSR operation according to the following table.4.2 inch Information Display
System status
Condition
Display on combination meter
Upper part
Middle part
TSR OFF
--
--
TSR ON
Road sign not detected
--
Road sign detected (except for speed limit signs)
--
This is an example. For details of displayed signs, Refer to System Description .
Road sign detected (Speed limit signs)
This is an example. For details of displayed signs, Refer to System Description .
This is an example. For details of displayed signs, Refer to System Description .
7 inch Information DisplaySystem status
Condition
Display on combination meter
Upper part
Middle part
TSR OFF
--
--
TSR ON
Road sign not detected
--
Road sign detected (except for speed limit signs)
--
This is an example. For details of displayed signs, Refer to System Description .
Road sign detected (Speed limit signs)
This is an example. For details of displayed signs, Refer to System Description .
This is an example. For details of displayed signs, Refer to System Description .
INSPECTION END