Fail-Safe (Around View Monitor Control Unit)

WARNING: This page is about a different car, the 2021 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

DTC Display contents of CONSULT	Malfunction detection condition	Fail-safe condition
U0428-00: ST ANGLE SENSOR CALIBRATION	Neutral position adjustment of steering angle sensor is not complete.	Predicted course line is not displayed.
U1000-00: CAN COMM CIRCUIT	When around view monitor control unit cannot transmit/receive CAN communication signal continuously for 2 seconds or more.	The following functions are disabled: When communication with steering angle sensor is not normal: Predicted course line is not displayed. When communication with ABS actuator & electric unit (control unit), TCM, BCM and ECM is not normal: MOD (Moving Object Detection) function is disabled. When communication with AV control unit is not normal: Intelligent around view monitor screen is not displayed. When communication with combination meter is not normal: MOD function cannot be turned ON/OFF. MOD function audible warning is disabled.
U1010-00: CONTROL UNIT (CAN)	CAN controller initialization error.	Intelligent around view monitor system is inoperative.
U111A-00: REAR CAMERA IMAGE SIGNAL	No-signal status of rear camera image signal is continued for 500 ms or more while ignition switch is ON.	Camera image is not displayed (gray or black screen display).
U111B-00: SIDE CAMERA RH IMAGE SIGNAL	No-signal status of side camera RH image signal is continued for 500 ms or more while ignition switch is ON.
U111C-00: FRONT CAMERA IMAGE SIGNAL	No-signal status of front camera image signal is continued for 500 ms or more while ignition switch is ON.
U111D-00: SIDE CAMERA LH IMAGE SIGNAL	No-signal status of side camera LH image signal is continued for 500 ms or more while ignition switch is ON.
U1232-00: ST ANGLE SEN CALIB	Neutral position adjustment of steering angle sensor is performed. NG signal from steering angle sensor is received.	Predicted course line is not displayed.
U1304-00: CAMERA IMAGE CALIB	When camera calibration is incomplete.	(red) is displayed.
U1305-00: CONFIG UNFINISH	Configuration is incomplete.	is displayed.