Special Repair Requirement

WORK PROCEDURE WHEN REPLACING AIR BAG DIAGNOSIS SENSOR UNIT 

1. SAVING VEHICLE SPECIFICATION 
   1. CONSULT Read out the vehicle specification from the old air bag diagnosis sensor unit and save the vehicle specification to CONSULT. Refer to "Configuration (reading) " in the "CONSULT Operation Manual".
      NOTE:

      • For the air bag diagnosis sensor unit, the Type ID is stored in CONSULT.
      • The Type ID is the part number (vehicle specification) that is to be written to the air bag diagnosis sensor unit.

   >>

   GO TO 2.

2. REPLACE AIR BAG DIAGNOSIS SENSOR UNIT 
   1. Replace air bag diagnosis sensor unit. Refer to Removal and Installation .

   >>

   GO TO 3.

3. WRITING VEHICLE SPECIFICATION 
   1. CONSULT Perform writing of the saved vehicle specification data according to the "Configuration" procedure in the "CONSULT Operation Manual". Refer to Work Procedure .

   >>

   Work End.

WORK PROCEDURE WHEN REPLACING OCS CONTROL UNIT 

1. PERFORM ZERO POINT RESET 
   1. Perform zero point reset. Refer to Special Repair Requirement .

   >>

   Inspection End.