Work Procedure

There is no vehicle specification in the new IPDM E/R, so the vehicle specification needs to be written in IPDM E/R with CONSULT.

Configuration has three functions as follows.

Function		Description
Before ECU Replacement		Reads the vehicle configuration of current IPDM E/R Saves the read vehicle configuration
After ECU Replacement	FAST linked	NOTE: This item is displayed, but cannot be used
After ECU Replacement	Manual selection	Writes the vehicle configuration with manual selection.

CAUTION:

Never perform vehicle configuration other than performing with a new IPDM E/R or the control function may not operate normally.

WRITING MODE SELECTION
1. CONSULT Reads the vehicle specification.
When writing saved data (able to be read) >>

GO TO 2.

When writing manually (could not be read) >>

GO TO 3.
PERFORM WRITING SAVED DATA
1. CONSULT
  1. Ignition switch ON.
  2. Select "Re/programming, Configuration". Select the vehicle specifications saved with "Before ECU Replacement" and then write them to the replacement IPDM E/R.
>>

GO TO 5.
PERFORM WRITING MANUALLY (IPDM E/R)
1. CONSULT
  1. Ignition switch ON.
  2. Select the "IPDM E/R" of "Re/programming, Configuration".
  3. Select the "Type ID" searched by using FAST (service parts catalog) to write the "Type ID" into the IPDM E/R.
    CAUTION:
    Check the "Type ID" accurately. If the "Type ID" is selected incorrectly, ECU control may not function normally.
>>

GO TO 4
OPERATION CHECK
1. Confirm that each function controlled by IPDM E/R operates normally.
>>

Work End.