Work Procedure

Always perform the rear automatic braking system action test to check that the system operates normally after replacing the ADAS control unit or repairing any rear automatic braking system malfunction.

1. CHECK RAB SYSTEM SETTING 
   1. Start the engine.
   2. Check that the RAB system setting can be enabled/disabled on the information display.
   3. Turn OFF the ignition switch and wait for 30 seconds or more.
   4. Check that the previous setting is saved when the engine starts again.

   >>

   GO TO 2

   .

2. CHECK RAB SYSTEM 
   1. Enable the setting of the RAB system on the information display.
   2. Check RAB warning lamp is OFF.

   >>

   INSPECTION END